Quck answer
Fixing a hole in a pool without draining the water is possible with the following steps:
1. Identify the location of the hole by inspecting the pool’s surface and looking for bubbles or water leakage.
2. Clean the area around the hole to remove any dirt or debris.
3. Apply a pool patching kit or underwater adhesive to cover the hole. Ensure that the patch is larger than the hole for better adhesion.
4. Smooth out the patch and press it firmly onto the hole, making sure there are no air bubbles trapped underneath.
5. Allow the patch to dry completely before using the pool again.
Remember to follow the instructions provided with the patching kit for the best results.
Most above-ground pools are equipped with a repair kit to address any damage that may occur to the sides or bottom of the pool. These pools are made of a durable PVC material that can withstand the pressure of water for many years. However, over time, the walls can weaken due to constant exposure to chlorine and sunlight. Occasionally, something may puncture the pool, causing a hole. You can fix this hole without draining the pool by using a waterproof epoxy patch.
Step 1
First, locate the area where the hole is located.
Step 2
Next, clean the area around the hole using a cloth. Make sure to wipe an area that is approximately 3 inches wider than the hole to remove any dirt or contaminants, such as skin oils or sunscreen, that could prevent the patch from sticking.
Step 3
Then, cut a patch from the material that is at least 1 inch larger than the hole on all sides.
Step 4
Apply cement to the entire underside of the patch.
Step 5
Fold the patch in half and submerge it underwater. Open up the patch and press it onto the hole, starting from the center and working your way outward.
Step 6
If the hole is located on a wall, patch the outside of the pool after patching the inside. Cut a patch of the same size as the one used inside.
Step 7
Clean the area around the hole with a cloth and ensure that the surface is completely dry.
Step 8
Finally, apply the patch to the hole and smooth it out from the center towards the edges.
