Quck answer
To use a Black & Decker Steam Iron Advantage, follow these steps:
1. Fill the water tank: Remove the water tank cover and fill it with tap water. Make sure not to exceed the maximum fill line.
2. Plug in the iron: Plug the iron into a power outlet and set the temperature dial to the desired heat setting.
3. Allow the iron to heat up: Wait for the iron to heat up. The indicator light will turn off when it reaches the set temperature.
4. Start ironing: Place the iron on the fabric and press the steam button to release steam. Move the iron in a smooth, continuous motion to remove wrinkles.
5. Refill the water tank: When the water level is low, unplug the iron and refill the water tank. Repeat steps 2-4 to continue ironing.
6. Safety precautions: Always unplug the iron when not in use and never leave it unattended. Follow the manufacturer’s instructions for cleaning and maintenance.
By following these simple steps, you can effectively use a Black & Decker Steam Iron Advantage to achieve wrinkle-free clothes.
The Black & Decker Steam Advantage is a versatile iron that offers various features. It can be used for dry ironing, steam ironing, or as a steamer for clothes on a hanger. It is extremely convenient and even includes a self-cleaning function to keep the Steam Advantage in good condition for a long time. The easy fill feature also ensures that there are no spills when setting up the iron.
Preparation
To add water to the iron, make sure it is not plugged into an outlet. Then, press down on the top of the water fill cover to remove the top.
Slightly tilt the iron and slowly pour water into the fill cup until it reaches the “MAX” line. Push up on the water fill cover until it snaps back into place. Once that is done, plug the iron into an electrical outlet. You will know it is working if the red power light turns on.
Steam Ironing
Select the desired steam level using the selector. Adjust the fabric dial to the appropriate setting for the clothing you are ironing. If you are unsure, refer to the fabric label on the clothing.
Wait for the indicator light to turn off, indicating that the Steam Iron Advantage is preheated and ready to use. This typically takes one to one-and-a-half minutes. Once the iron is heated, it can be used like any other iron. The steam cycle is automatic and will steam clothing without any dripping or leaking.
Dry Ironing
Turn the steam selector to “OFF.” Adjust the fabric select dial to the suitable setting for the type of clothing you are ironing, based on the fabric label and the fabric guide on the heel of the iron. Iron your clothing as usual. No steam will be released while the iron is on this setting.
Surge of Steam or Vertical Steaming
Set the temperature dial to four or higher, depending on the fabric type you want to steam. Hang the garment you want to steam on a hanger in an easily accessible area.
Hold the iron three inches away from the fabric and stretch the fabric taut with one hand. Keep holding the fabric taut while pressing the “Surge of Steam” button on the Black & Decker Steam Advantage five times. Wait five seconds and then press the button again. Move the iron from section to section as you remove wrinkles from the garment.
Self Cleaning
To clean the iron, fill the water reservoir halfway to the “MAX” line. Set the fabric dial to six, and stand the iron upright until the heat light turns off and then comes back on.
Switch the fabric dial to “MIN” and unplug the iron. Hold the Steam Advantage over a sink with the sole plate facing down. Turn the selector button to “Self Cleaning.” Steam and hot water will be released through the vents on the sole plate.
Keep holding until all the steam and water has been released, then let go of the selector button. Stand the iron upright, plug it in, and let it heat for two minutes to finish the cleaning process.
Important Information
If the iron is left unused for 10 minutes, it will automatically shut off. When cleaning the iron, make sure to wear an oven mitt to prevent steam burns or other injuries.
