Quck answer
If your Bissell carpet cleaner is not releasing water, there are a few troubleshooting steps you can take:
1. Check the water tank: Ensure that the water tank is properly filled and seated in its place. If the tank is not securely attached, the cleaner may not dispense water.
2. Clean the spray nozzle: The spray nozzle may be clogged with debris or detergent residue. Remove the nozzle and clean it thoroughly to ensure proper water flow.
3. Check the water pump: The water pump may be malfunctioning. Test the pump by turning on the cleaner and listening for a humming sound. If there is no sound, the pump may need to be replaced.
4. Inspect the water lines: Check the water lines for any kinks or blockages. Straighten any kinks and clear any obstructions to restore water flow.
By following these troubleshooting steps, you can address the issue of a Bissell carpet cleaner that is not dispensing water.
Bissell manufactures various machines specifically designed for cleaning hard floors and carpets. The company offers a range of carpet cleaners that use a combination of water and cleaning solution to remove stains from carpets. However, after extended use, the carpet cleaner may experience a malfunction where it fails to dispense water. In order to identify the cause of this issue, a troubleshooting process needs to be conducted. In most cases, the problem can be resolved by removing any fiber clogs that are blocking the water from coming out of the nozzles.
Step 1
Firstly, grasp the cleaning solution tank and remove it from the machine. Then, reinsert the tank back into the machine, ensuring that it fits securely. If the tank is even slightly dislodged, water will not be able to enter the machine. Take a visual inspection of the siphon tube on the tank to confirm that it is not being pressed against the wall of the carpet cleaner.
Step 2
Tilt the handle of the carpet cleaner downwards until it rests on the floor. Examine the bottom of the machine and remove any visible carpet fibers or hair clogs that may be stuck in the water nozzles.
Step 3
Push the nozzle cover downwards towards the machine wheels to detach it. Then, pull up on the spray tip itself to remove it from the machine.
Step 4
Soak the spray tip in a sink filled with warm water for a period of five to ten minutes in order to clean any clogs from the nozzle holes. Dry off the nozzle tip with a towel and reattach it along with the nozzle cover back onto the vacuum.
Step 5
Fill the water tank with water until it reaches the fill line. Fill the dirty water tank with clean water until it reaches the maximum water line. Plug the machine in and turn it on. Press the trigger located in the handle for 60 seconds to attempt to force water through the system.
