Quck answer
Swiffer WetJet is a popular cleaning tool, but sometimes it can encounter problems. Here are some troubleshooting tips:
1. Check the batteries: Ensure that the batteries are properly installed and not depleted. Replace them if necessary.
2. Unclog the nozzles: If the solution isn’t spraying properly, the nozzles may be clogged. Remove the bottle and clean the nozzles with warm water.
3. Check the solution bottle: Make sure the solution bottle is securely attached and not empty. Refill or replace it if needed.
4. Clean the mop pad: If the pad isn’t picking up dirt or leaving streaks, it may be dirty. Remove and wash the pad according to the manufacturer’s instructions.
5. Contact customer support: If the problem persists, reach out to Swiffer’s customer support for further assistance.
Remember to always follow the instructions provided by Swiffer to ensure optimal performance and safety.
The Swiffer WetJet is a cleaning system that consists of a two-nozzle sprayer, a cleaning pad, and a scrub strip. The sprayer connects to a reservoir filled with cleaning solution. If you encounter any problems with the spray system or the cleaning solution tank, you can troubleshoot to try and fix the issue. Many common issues with the Swiffer WetJet can be resolved on your own.
Step 1
Prior to using the Swiffer WetJet, make sure to vacuum or sweep the area to remove any large dust or dirt particles. Streaks may occur if you don’t use enough cleaning solution. Make sure to apply sufficient cleaning solution to wet the entire area.
Step 2
If the sprayer is not working, check to ensure that the bottle is fully inserted. Insert the bottle completely and securely. Also, check if the batteries have been properly inserted. If the motor doesn’t operate even after checking the solution bottle and batteries, replace the old batteries with new ones.
Step 3
If the cleaning pad is not staying attached to the bottom of the device, check its position. It might have been installed upside down. Remove the pad and attach the side that says “Swiffer” directly to the Swiffer WetJet.
Step 4
If cleaning solution is leaking from the Swiffer WetJet, check the position of the cleaning solution bottle. Remove the bottle, insert it completely and securely into the WetJet.
Step 5
If there are stubborn stains or spots that don’t come off after using the WetJet, soak them with cleaning solution. Spray the cleaning solution on the spots or stains and let it sit for five minutes. If the scrubbing strip is dirty, replace it and scrub the area.
