Quck answer
Reprogramming your Wayne Dalton garage door opener is a simple process that can be done in a few steps. First, locate the programming button on your opener. Press and hold this button until the LED light on the opener starts flashing. Then, press the button on your remote control that you want to program. The LED light on the opener will flash again to confirm the programming. Finally, test the remote control to ensure it is working properly. By following these steps, you can easily reprogram your Wayne Dalton garage door opener.
Wayne Dalton is a well-known wireless system for opening garage doors that offers remote openers and remote keypads. These products allow you to control your garage door from inside your house or car, and even from a distance of several hundred feet. You can easily adjust or modify the settings of both your wireless remote and keypad in just a few minutes from your garage. This process doesn’t require any prior experience and your remotes will be ready to use immediately.
Programming the Keypad
Step 1
Press the “Program” button on your garage door motor and wait for the red indicator light to start flashing for 30 seconds.
Step 2
Press the “On/Off/Reset” button on your keypad and wait for the light on the keypad to turn on.
Step 3
Select a four-digit code for your opener and enter it on the keypad.
Step 4
Hold down the “0” button on your keypad until the garage door responds by either opening or closing.
Programming the Remote
Step 1
Hold down the button that you want to program on your remote until the indicator light on the remote turns on and then off.
Step 2
Press the “On/Off/Reset” button on your keypad until the indicator light turns on and enter your four-digit passcode.
Step 3
Wait for the indicator light on your remote to flash and then press the programmed button on the remote to operate your garage door.
