Quck answer
To remove a Lutron switch plate, follow these steps:
1. Turn off the power: Locate the circuit breaker for the switch and turn it off to ensure your safety.
2. Unscrew the switch plate: Use a screwdriver to remove the screws holding the switch plate in place. Set the screws aside for later use.
3. Gently pull the switch plate: Carefully pull the switch plate away from the wall, being cautious not to damage the wires connected to the switch.
4. Disconnect the wires: Once the switch plate is loose, disconnect the wires from the switch. Take note of the wire connections or take a picture for reference.
5. Remove the switch plate: Completely remove the switch plate from the wall and set it aside.
With these steps, you can easily remove a Lutron switch plate for replacement or maintenance purposes.
Lutron switch plates offer a sleek and modern appearance to any room due to their design that eliminates visible screws. While the smooth surface of a Lutron plate may be aesthetically pleasing, it can be confusing when you need to remove the plate for cleaning or to access the actual switch. Surprisingly, the process of removing a Lutron switch plate is quite simple and only requires a tool that you likely already have.
Step 1
To begin, turn off the power supply to the room where you will be removing the Lutron switch plate. Locate your fuse box, which should be labeled with each fuse switch and the corresponding room it controls. If the labels are not present, you can turn off the switches one at a time and check the room for power by attempting to turn on a light switch.
Step 2
Using a flathead screwdriver, gently pry the frame off the switch plate. Work your way around the frame, applying small amounts of pressure as you go. Once the frame becomes loose, you can pull it off completely.
Step 3
With the flathead screwdriver, pry the switch plate up from beneath the clips that were concealed by the frame. Depending on the model of your Lutron switch plate, there may be an additional screw in the center holding it in place. If this is the case, remove the screw.
Step 4
Now, pull the switch plate out of the switch box. You will notice two wires connecting the switch plate to your house’s electrical wiring. Pinch each wire between your thumb and forefinger, and pull them out of the pressure clip that holds them in place at the back of the switch plate.
