Quck answer
Replacing fuses in Whirlpool microwaves is a simple process that can be done at home. Here are the steps to follow:
1. Unplug the microwave and locate the fuse. It is usually located near the power cord inside the microwave.
2. Use a screwdriver to remove the screws holding the outer cover of the microwave in place.
3. Once the cover is removed, find the fuse holder and carefully remove the old fuse.
4. Insert a new fuse of the same type and rating into the fuse holder.
5. Put the cover back on and secure it with the screws.
6. Plug the microwave back in and test if it is working properly.
Following these steps will allow you to replace fuses in Whirlpool microwaves and get them working again.
One common issue with Whirlpool microwaves is a faulty fuse. Fortunately, most modern microwaves use a standard type of fuse that can be easily found at appliance and electronics stores. The process of replacing the fuse in a Whirlpool microwave may vary depending on whether it is a countertop or built-in microwave. However, having a clear starting point can simplify the process for both types.
Countertop Microwaves
Step 1
Before starting any repairs, unplug the microwave and allow it to sit for a few minutes. Choose a clear workspace with ample room to work around the microwave, ensuring access from all sides.
Step 2
Remove the Phillips screws that secure the outer shell of the microwave. These screws are typically located along the lower sides and edges of the back panel. Place the screws in a bucket or bowl to keep them together. Gently pull the shell away from the microwave and set it aside.
Step 3
Locate the fuse within the exposed control area of the microwave. The fuse is housed in a small receptacle with two wires connected to it. Using a flat screwdriver, carefully pry up from the bottom of the fuse to remove it. Insert a new fuse in its place.
Built-in Microwaves
Step 1
Just like with countertop microwaves, start by unplugging the built-in microwave and allowing it to sit for a few minutes before beginning any repairs.
Step 2
Open the microwave door and look for two Phillips screws on the left side of the control panel. Unscrew and remove these screws. Lift the control panel upward and tilt it outward. The control panel will rest on its hinges.
Step 3
Locate the fuse receptacle within the control area. It is usually positioned to the left or center of the microwave cavity. You will see two wires connected to a small plastic receptacle. Use a flat screwdriver to gently pry up from the bottom of the fuse and remove it. Replace the fuse with a new one.
