Quck answer
To program a Genie Intellicode remote control, follow these steps:
1. Locate the “Learn” button on your Genie Intellicode opener. It is usually located on the back panel or under the light cover.
2. Press and release the “Learn” button. The indicator light on the opener will start blinking.
3. Within 30 seconds, press and hold the button on the remote control that you want to program. The indicator light on the opener will stop blinking and stay lit.
4. Release the button on the remote control. The programming is now complete.
5. Test the remote control by pressing the programmed button to operate the garage door opener.
Remember to consult your Genie Intellicode opener manual for specific instructions, as the programming process may vary depending on the model.
The Genie company has developed the Intellicode system, which is a specialized technology for garage door openers. It continuously changes digital codes to prevent unauthorized access to your garage through electronic hacking. This system is now used in most of Genie’s garage door openers, which come with pre-coded remote controls. However, you can also pair your Genie opener with aftermarket remote controls from other manufacturers, which require programming to match your opener. Additionally, there may be situations where you need to reprogram your existing remote control or add a new device to replace a lost remote. In case a remote control is stolen, it is crucial to reprogram your opener with a new code. The process of programming a keypad entry control is similar.
Fortunately, programming the remote control is a simple task. Although the appearance of the garage door opener’s controls may vary depending on the model and year, the process remains virtually the same for all Genie Intellicode openers.
Find the “Learn Code” Button
First, set up a stepladder and locate the LEARN CODE button and LED indicator on the motor unit of the garage door. It is usually found at the front end of the center track, overhead. The “Learn Code” button is typically near the antenna of the unit, either on the outside of the motor casing or behind the plastic light bulb covering. In some cases, you may need to remove the covering by unscrewing the Phillips-head screws.
Program the Remote Control
- Press and release the LEARN CODE button on the motor housing. The LED indicator will blink twice per second for about 30 seconds, so act quickly.
- Press and release the button on the remote control you want to program. The LED indicator light on the motor housing should flash or glow steadily, depending on the model.
- Press the same button on the remote control again to turn off the LED indicator.
- To verify that the button has been programmed correctly, press it on the remote control again. The garage door should operate. If it doesn’t, carefully repeat the steps above.
- Repeat the above steps for multiple doors and/or remotes with multiple buttons. Most Intellicode garage door openers can be programmed for at least seven different remote controls, or six remotes plus a wireless keypad.
